Cookie Img Back to top
   Call Me Free Offline Send Inquiry
Home » Products » Foundry Chaplets

Foundry Chaplets

motor chaplets
close
motor chaplets
xc01
Moter chaplets are manufactured from mild steel, generally coated with tin and used in thin-walled casting.
separator chaplets
close
separator chaplets
separator
Separator chaplets are manufactured from mild steel, generally coated with tin, and used in water jacket cores in the casting of engine blocks.
double head chaplets
close
double head chaplets
xc04
Double head chaplets are manufactured using mild steel, generally coated with tin and used when casting a heavy metal section where the increased strength resulting from welding the chaplets is required.
vents tubes
close
vents tubes
xcgz
Tubes are manufactured using tin coated sheet steel or non-ferrous sheet, depending on the metal being cast. Primarily they are used to core holes in heavy metal sections, chill metal in castings, or reinforce and ventilate cores. The following design features may be considered. Butt seam, overlapped seam or welded seam, solid material or perforated material, flanges on the ends, indentations, protrusions, and tabs, wings, or ears.
Chaplet Core Support
close
Chaplet Core Support
xc06
Core chaplets are necessary for casting designs. They are effective for core prints, or when the core is possible to sag, shift position or float. Core chaplets are manufactured from low carbon steel, or same material as with casting. It is tin-coated (electroplated or hot dipped), so as to prevent oxidation and contamination.
triple head chaplets
close
triple head chaplets
xc02
Triple head chaplets are used in castings where two head chaplets do not knit ot fuse, creating a defect in the casting, usually porosity. By adding a third plate known as the center dam into the design of the chaplet, this feature can eliminate the defect in the castings.